PNY P-DSA2-PCIE-RF user manual installation. To make this floppy disk, copy the contents of

installation. To make this floppy disk, copy the contents of

the “PCI_IO\SiI3132\Driver\RAID\FLOPPY” folder, found on the driver CD, onto a blank floppy disk then follow the directions below.

1.Setup the RAID Array prior to Windows installation.

2.Follow Windows® 2000 installation procedure.

3.Restart the computer when prompted by the installation.

4.At the Windows® 2000 Setup screen, press F6 to install the RAID driver.

5.When prompted, press S to specify the location of the driver.

6.Insert the floppy disk, then press Enter.

7.Select Silicon Image SiI 3132 SoftRAID 5 Controller for Windows 2000, then press Enter.

8.Press Enter again to finish driver installation, then follow the on-screen instructions to complete the Windows installation.

For An Existing Installation

1.Setup the RAID Array prior to driver installation and boot up to Windows.

2.At Found New Hardware Wizard, click Next.

3.Select Search for a suitable driver for my device (recommended) then click Next.

4.Insert the provided driver CD into your CD-ROM Drive, check

Aug/07 13 MN2036400001