8.Using a New Accessory Teaching
Your CS600X Training System has been synchronized, or “taught” to work together with the Polar WearLink W.I.N.D. transmitter and to measure heart rate, speed and distance. In other words, your Training System receives signals from your transmitter and speed sensor only, and enables
If you purchase a new transmitter or speed sensor as a separate accessory, they have to be introduced to the Training System. This is called teaching and takes only a few seconds.
To prevent interference during a riding event, make sure you perform the teaching process prior to the event.
Teach New Transmitter
Wear the transmitter and make sure that you are not near (40 m/131 ft) other Polar WearLink W.I.N.D. transmitters. In time mode, press OK. The Training System starts searching for the transmitter signal.
Once the new transmitter is identified, New WearLink found, Teach new WearLink? is displayed.
∙Select Yes to confirm teaching. Completed! and Exercise displays updated are displayed. Start exercise recording by pressing OK.
∙Select No to cancel teaching.
Teach New Speed Sensor
Make sure that there are no other speed sensors or Training Systems nearby (40 m/131 ft). The teaching procedure only takes a few seconds.
You can teach one Speed sensor for each sulky setting.
Select Settings > sulky > sulky1 > Speed > On/Off
Select > On > Teach new sensor? is displayed
∙Select Yes to confirm teaching > Start test drive is displayed. Rotate the wheel a few times to activate the sensor. A flashing red light indicates that the sensor is activated.
Completed! and Exercise displays updated are displayed. The Training System is now ready to receive speed and distance data.
∙Select No to cancel teaching and the already earlier taught speed sensor is taken into use.
