Polk Audio PA200.4 B rBridgedd g e d, English, SPEAKERWIRING DIAGRAMS PA1100.5, ChannelH

FIGURE 4—SPEAKER WIRING DIAGRAMS (PA1100.5)

Front/Rear Operation (top view)

ChannelH 1 F R 1O NFrontT

ChannelH 2 Front

2 F R O N T

ChannelH 3 R E3ARear

Channel 4 Rear

C H 4 R E A R

Front/Rear Bridged Operation (top view)

ENGLISH

FIGURE 4—SPEAKER WIRING DIAGRAMS (PA1100.5)

Subwoofer Operation (top view)

ChannelH 1	d
	rBridgedd g e
ChannelH22	B
	S U B +

SubwooferU B W O O F E R

Channel 3
C H 3	rBridgedd g e d
Channel 4	B
H 4
	S U B -

CROSSOVER SETTINGS

AND GAIN ADJUSTMENT

FrontR O N T ChannelH 11

Channel 2

C H 2

RearE A RChannelH 33

ChannelH 44

B rBridgedd g e d

B rBridgedd g e d

Your Polk Audio power amplifier needs to be adjusted carefully to achieve maximum performance. These are some guidelines to follow when fine-tuning the amplifier.

•For full-range and simultaneous stereo/mono bass applications, the crossover selection switch should be set to FULL. If the amplifier is driving your sub- woofers, set the switch to LOW, and for mid-bass/ midrange output, set to HIGH.

•The crossover frequency control needs to be adjusted to suit your particular system. For subwoofer appli- cations, try and keep the setting low enough to prevent image smearing (you should not be able to hear male voices from the subwoofer) but not so low as to create a gap between the subwoofer and the mid-bass/ midrange speakers. For mid-bass/midrange settings, try to keep the setting low enough to keep your sound stage in front of you, without overdriving the speaker. It will be to your advantage to spend some extra time with this adjustment, listening to familiar music or system set-up discs to achieve the kind of musical reproduction that you prefer.

•The gain adjustment allows you to set proper signal match for clean, quiet amplifier operation. For full-range and simultaneous stereo/mono bass applications, start

by playing some music you are familiar with. With the gain adjustment on the amplifier in the middle of its rotation, bring up the volume on your head unit to the 3/4 volume setting or until you start to hear distortion or clipping. If you hear distortion before you reach the 3/4 volume setting of your head unit, reduce the gain setting on the amplifier and start to raise the head unit volume again. When you can listen to the music at or slightly above 3/4 on your head unit without audible distortion, slowly raise the gain of the amplifier until distortion is heard, then back off the gain until the distortion is not audible. This setting will allow you to reach full output with all but the quietest of source material, while avoiding excessive noise in the system.

NOTE: Polk amplifiers use a digital gain control with

a finite number of adjustment steps. A very small adjust- ment may not cause any audible change in level.

14 P A 1 2 V A M P L I F I E R S W W W . P O L K A U D I O . C O M / A M P S 15