![](/images/new-backgrounds/1107115/10711549x1.webp)
Release Notes - SIP ApplicationChanges
2.6.4 Configuration File Parameter Changes
.cfg | Action | Parameter | Description |
File |
|
|
|
sip | added | voIpProt.SIP.useContactInReferTo | 0 = default behavior which is the same as |
|
|
| previous behavior, use URI from initial |
|
|
| call’s To header in REFER’s |
|
|
| header |
|
|
| 1 = use URI from initial call’s Contact |
|
|
| header in REFER’s |
|
|
| setting up a transfer |
sip | added | voice.gain.rx.analog.chassis.IP_330 | New parameters to support SoundPoint |
|
| voice.gain.rx.analog.ringer.IP_330 | IP 320 and 330 platforms which will be |
|
| voice.gain.rx.digital.chassis.IP_330 | supported in a future software release. Do |
|
| voice.gain.rx.digital.ringer.IP_330 | not change these values. |
|
| voice.gain.tx.analog.chassis.IP_330 |
|
|
| voice.gain.tx.digital.chassis.IP_330 |
|
|
| voice.rxEq.hs.IP_330.preFilter.enable |
|
|
| voice.rxEq.hs.IP_330.postFilter.enable |
|
|
| voice.rxEq.hd.IP_330.preFilter.enable |
|
|
| voice.rxEq.hd.IP_330.postFilter.enable |
|
|
| voice.rxEq.hf.IP_330.preFilter.enable |
|
|
| voice.rxEq.hf.IP_330.postFilter.enable |
|
|
| voice.txEq.hs.IP_330.preFilter.enable |
|
|
| voice.txEq.hs.IP_330.postFilter.enable |
|
|
| voice.txEq.hd.IP_330.preFilter.enable |
|
|
| voice.txEq.hd.IP_330.postFilter.enable |
|
|
| voice.txEq.hf.IP_330.preFilter.enable |
|
|
| voice.txEq.hf.IP_330.postFilter.enable |
|
sip | added | voice.vad.signalAnnexB | A new line can be added to SDP |
|
|
| depending on the setting of this |
|
|
| parameter and the voice.vadEnable |
|
|
| parameter. |
|
|
| Default behavior is the same as |
|
|
| voice.vad.signalAnnexB = 0: |
|
|
| No change to the SDP |
|
|
| voice.vad.signalAnnexB = 1: |
|
|
| If voice.vadEnable=1, add attribute line |
|
|
| a=fmtp:18 annexb=”yes” |
|
|
| below a=rtpmap… attribute line (where |
|
|
| ‘18’ could be replaced by another |
|
|
| payload) |
|
|
| If voice.vadEnable=0, add attribute line |
|
|
| a=fmtp:18 annexb=”no” |
|
|
| below a=rtpmap… attribute line (where |
|
|
| ‘18’ could be replaced by another |
|
|
| payload) |
Copyright © 2007 Polycom, Inc. | Page 19 |