![](/images/new-backgrounds/1107115/107115123x1.webp)
Release Notes - SIP Application | Notes |
line will be added to SDP. See details in 2.6.4 Configuration File Parameter |
|
Changes. |
|
3.1.7 From Version 2.0.3 to 2.1.0
3.1.7.1 Mandatory Changes
•Using a Microsoft LCS Server
It may be required to set the new parameters voIpProt.server.x.lcs (in sip.cfg) and reg.x.server.y.lcs (in phone1.cfg) if the phone registers to a Microsoft LCS server.
3.1.7.2 Optional Changes
•Using “inactive” stream mode attribute when a call is put on hold
The default behavior is for the “sendonly” stream mode attribute to be used when a call is put on hold. This behavior can be changed to use the “inactive” attribute. In order to configure this behavior, the parameter voIpProt.SIP.useSendonlyHold must be set to 0.
•Digit map extension support
The digit map can be configured to remove, add or replace digits. For details see Technical Bulletin 11572.
•Restricting transport to TCP
The transport used by the phone can be restricted to TCP. This means the phone will not attempt to fail over to UDP if TCP fails. A new “TCPOnly” option has been added to all parameters which control the transport used by the phone.
•Adding “sticky line seize” behavior for
If sticky behavior is desired for hot dialing this can be configured using the new call.sticky.AutoLineSeize.onHookDialing parameter. Hot dialing sticky behavior can be configured to be different than normal new call sticky behavior. “Stickiness” refers to using the same line for a new call as the
3.1.8 From Version 2.0.3 to 2.0.3 B
3.1.8.1Mandatory Changes
None.
3.1.8.2Optional Changes
None.
3.1.9 From Version 2.0.2 to 2.0.3
3.1.9.1Mandatory Changes
None.
3.1.9.2Optional Changes
None.
Page 56 | Copyright © 2007 Polycom, Inc. |