Polycom 725-78600-002A2 manual Small fixed

Rack Installation Polycom Digital Signage Server Hardware Setup

NOTE: The following installation procedures are for use with the rails and hardware provided in your ship kit. If different style rails are being used, or if your rack requires different hardware, refer to the instructions provided with your rail or rack ship kit.

NOTE: When removing the appliance from the 2-post rack, you will need to press down on the right locking tab and lift up on the left locking tab in order to release it from the rack. Carefully slide it out supporting the unit on both sides at all times.

Step 1

•Locate the two long and six short rack brackets that came in your ship kit.

•Securely attach the set of short brackets with the threaded screw holes to the long bracket in the front as shown. Use two M4 truss head screws for each bracket.

•Loosely attach one set of the other short brackets to the long fixed bracket as shown using one M4 truss head screw on each bracket. The three holes on the flap will face toward the back for later attachment to the 2-post rack.

•Loosely attach the remaining set of short brackets to the long fixed bracket as shown using one M4 truss head screw on each bracket. The three holes on the flap will face toward the front for later attachment to the 2-post rack.

C	Small fixed	Long bracket
	rack brackets

B

A		C
		B
	Small fixed
	rack brackets with	A
	threaded holes
		Two M4 truss
		head screws

Small fixed rack brackets

One M4 truss head screw

Step 2

•Attach the assembled brackets to the 2-post rack.

•Insert two M5 x 12 flat head screws through the short brackets into the

2-post rack (in the front and back of therack as shown) and tighten. Make sure the brackets are aligned and level in height, not only in the front and back but also on the left and right sides.

Polycom, Inc. 15