4.Guide the straight end of each retaining clip through the saddle hole and both handle holes.
5.Rotate each retaining clip and press down until it snaps into place over the handle.
6.If the handle has excessive movement, it is improperly installed. Check the following.
A.Are both tabs inside the handle?
B.Does each clip pass through both the saddle and handle?
Retaining
Clip
Handle
Inserted
On Tabs
Handle
To Assemble Wheels
It will be necessary to brace or support one side of the unit when installing the wheels because the compressor will have a tendency to tip.
1.Attach wheels with shoulder bolts and nuts as shown.
2.Tighten securely. NOTE: The unit will sit level if the wheels are properly installed.
Nut
Wheel
The wheels and handle do not provide adequate clearance, stability or support for pulling the unit up and down stairs or steps. The unit must be lifted, or pushed up a ramp.
Shoulder Bolt
Assemble Rubber Feet
1.Attach rubber feet with the screws, washers, and nuts provided as shown.
2.Tighten securely.
INSTALLATION
HOW TO SET UP YOUR UNIT
Location of the Air Compressor
Nut
Flat
Washer
Rubber Foot
Screw
•Locate the air compressor in a clean, dry and well ventilated area.
•The air compressor should be located at least 12" (30.5 cm) away from the wall or other obstructions that will interfere with the flow of air.
•The air compressor pump and shroud are designed to allow for proper cooling.
Do not place rags or other objects on top of compressor.
10- ENG
