POSIFLEX Business Machines TP/LT- 8000 Using The Touch Pos, Application Environment, Ventilation

Models: TP/LT- 8000 TP/LT- 5800 TP/LT- 5700 TP/LT- 5600

1 20
Download 20 pages 40.61 Kb
Page 14
Image 14
USING THE TOUCH POS

USING THE TOUCH POS

APPLICATION ENVIRONMENT

It is very important that you check the following operational guidelines:

Ventilation

This terminal must NOT be operated in an environment with restricted ventilation. The installation should be such that there is at least 25mm air clearance around any top or side ventilation holes. The installation must also be such that there is a free flow of air around the unit at ALL times.

Operating Environment

The equipment must not be operated or stored in extremes of both temperature and humidity/moisture. (Operating range 5°C to 40°C and up to 80% humidity – non condensing)

UPS Battery (option)

General care:

The UPS battery is consumables beyond product warranty. Please definitely observe the alerts in beginning of this manual. If the equipment is to be powered off for more than few days, please always disconnect the battery from the system. Reconnect it and turn on the system to recharge the battery for 1 ~ 2 hours every 3 months for temperature lower than 30°C. Recharge for 1 ~ 2 hours every month for temperature over 30°C. Temperature above 40°C must be strictly avoided as it could cause termination of battery life and unexpected result even if the battery is not in work. The UPS battery can support basically the data preservation and smooth running of the system during intermittent or few minutes (3 ~ 8 min. for TP/LT-5600/5700/5800 or 2

~6 min. for TP/LT-8000 depending on loading and battery condition) power failure.

Battery replacement:

In the preloaded OS for a Jiva system, there is a built in utility Power Manager that will interface the UPS battery monitor status with user. When battery monitor disables the battery charging as designed while the UPS function of the system is originally enabled, in other words the UPS battery is found out of order if actually installed, there will be a popup message as the picture at right asking the user to agree disabling the

UPS function. The system will operate under deactivated UPS function no matter agreed or not. However, the monitoring goes on and the popup

message will come back on next system power up boot if not agreed. In any case, please replace the used up UPS battery at power off if the battery is well

Part 14

Page 14
Image 14
POSIFLEX Business Machines TP/LT- 8000 Using The Touch Pos, Application Environment, Ventilation, Operating Environment