POSIFLEX Business Machines TP/LT- 5700, TP/LT- 5600 Base Mount Upgrade KIT, 15 2nd LCD Panel

in squares in lower left picture and allow the main unit to slide down the winding grooves in the wall mount backpack - originally the base box. The stand assembly is not engaged in wall mount operation. Connect all cables coming out of the backpack into the cable cover area of main unit.

The area required for wall mount application is determined by the main unit dimensions and is 375 mm in width and 315 mm in height.

BASE MOUNT UPGRADE KIT

On rear edge of the stand assembly, there is a rear connect cover. Either a 12” 2nd LCD display panel option LM-6201 or a VFD customer display option PD-2501 can be installed here for desktop mount application after removing this cover. However, the 15” 2nd LCD display can be installed without removing this cover.

12” 2nd LCD Panel Or Customer Display This rear connect cover can be removed

with metal chassis assembled in the base cover. Refer to the inside view of the base unit after

removal of UPS battery bracket at right use a flat head screwdriver to pick the plastic hook plate of the rear connect cover from inside to remove the cover.

Fit the latest base of PD-2501 or LM-6201 to the rear connect cover opening. For LM-

6201, please first route its cable through this opening and have it pass the passage arrowed in left picture. For PD-2501, please have its cable go through the

normal cable exit (under the joint base) as in the right picture.

Fit 2 screws through washers to hold the joint tight. For low profile customer display PD-305, the installation procedure is same. Remember to enable the +5 V DC supply in the COM port of main unit for PD-2501 or PD-305 or the system. Please note that if the base (joining mechanism) of the PD or LM is of older version for earlier large base of TP-59/70/82 series, there will be minor styling discrepancy with the universal base of the system.

15” 2nd LCD Panel

A bracket kit including a steel bracket and 2 types of screws as in the left picture will be provided with the 15” 2nd LCD panel. Use 3 smaller screws to fix the bracket to outside of

the bottom plate from inside as circled in the below left picture that is the bottom view of the base stand. Then use the 4 larger screws to fix the monitor support rod from bottom as arrowed in the same picture. The overall assembly

Part 8