http://www.posiflex. com.tw
DESKTOP MOUNTING
Matching Pegs Matching Holes
Round Part
Slot Part
Removal Hollow
Match the matching pegs on the back of the main unit against the matching holes on the stand assembly. First aim the matching pegs toward the upper round part of the hole and make sure that all pegs are inside the holes. Then slide the main unit down to move the pegs into the lower slot part of the holes till it clicks. Note that all the cables come out of the stand from the lower edge and won’t get trapped by this mounting operation. If later on you want to remove the main unit from the stand, you’ll have to press down the lock/release button on back of the stand at the time lifting the main unit.
For desk top/counter application, the adjustable stand assembly requires a base of 265 mm deep and 282 mm wide. However, please take also the main unit into consideration. If the main unit is tilted to near vertical position, the total height is 373 mm. When the main unit is tilted to near horizontal position, the total height required is 296 mm.
CONNECTING CABLES
When later the main unit and stand assembly are to be
Some connectors, such as the LAN connector, or the cash drawer connector have to be inserted until a click is heard. It is recommended that connectors such as the external VGA connector, the LPT port connector and the COM port connectors, be screwed into place once seated. If the COM1 port must be used, the COM1 terminator that occupies the COM1 port must be removed and safely preserved for future use. However, when using the COM1 port, it is advisable to use devices that provide proper hardware handshaking signals in order to keep other embedded system features. A serial mouse is one example of a device that does not support handshaking.
Adjust the slack of each cable and close the cable cover. Use the same
Part 11
