Chapter 6 Stabilizing the Cabinet

NOTE For seismic installations, you MUST order and install a Powerware 9355 UPS seismic kit; do not use the following instructions.

NOTE For non-seismic installations, you MUST install the stabilizing bracket on all 3-high cabinets. The stabilizing bracket is optional for 2-high cabinets.

1.Lower the leveling feet to prevent the cabinet from rolling.

Figure 27. Lowering the Leveling Feet

2.Attach the stabilizing bracket to the bottom of the cabinet rear panel using the retained hardware from the shipping pallet according to the cabinet configuration:

S For one cabinet, see Figure 28.

S For two cabinets, see Figure 29.

S For three cabinets, see Figure 30.

NOTE No more than three cabinets can be attached together. For four cabinets, use two of the two-cabinet installations. For five cabinets, use one three-cabinet and one two-cabinet installation.

3.Use the holes and slots in the bottom of the bracket to attach the cabinet to the flooring if desired.

EATON Powerware® 9355 UPS (10/15 kVA) User’s Guide S 164201594 Rev B www.powerware.com

39