Testing New Batteries | Powerware UPS 1000 - 2200 guide

4.1500 and 2200 VA units. Pull the battery out onto a flat, stable surface. Press on the black tab on the battery cable connector to disconnect the battery. See “Recycling the Used Battery” on page 20 for proper disposal.

5.Install the new batteries in the reverse order of removal.

6.Reinstall the metal battery cover removed in Step 2. Replace the front panel.

Testing New Batteries

Press and hold the button for three seconds to initiate a self–test. After the test is finished, the indicator should turn off. If the indicator stays on, check the battery connections. Call your service representative if the problem persists.

1019297	1000 - 2200 VA	19
Revision A	User’s Manual

Image 19

Powerware UPS 1000 - 2200 user manual Testing New Batteries

Contents

UPS 1000 2200 VA User’s Manual Page Table of contents Powerware 5125 User’s Manual 1000-2200 VA Copyright Class a EMC Statements VA Models Requesting a Declaration of Conformity Special Symbols Powerware Powerware 5125 Introduction Installing the UPS InstallationInspecting the Equipment UPS Rear Panels Installation Operating Modes Operation and Configuration Normal Mode Standby ModeBuck and Double Boost Mode Starting the UPS on Battery Battery ModeSleep Mode UPS Configuration Initiating the Self-Test Turning the UPS OffCommunication Port Network Transient Protector Network Transient Protector VA and 1500 VA Load Segments Load Segments Storing the UPS and Batteries UPS MaintenanceUPS and Battery Care When to Replace Batteries How to Replace Extended Battery Modules Use the following procedure to replace internal batteries Testing New Batteries Recycling the Used Battery TroubleshootingAudible Alarms and UPS Conditions Alarm or Condition Possible Cause Action Silencing an Audible Alarm 100% Dimensions W x D x H Weight Specifications Battery