Network Transient Protector | Powerware UPS 1000 - 2200 guide

Network Transient Protector

The Network Transient Protector, shown in Figure 9, is located on the rear panel and has jacks labeled IN and OUT. This feature accommodates a single RJ–45 (10BaseT) network connector.

Connect the input connector of the equipment you are protecting to the jack labeled IN. Connect the output connector to the jack labeled OUT.

Figure 9. Network Transient Protector

14	1000 - 2000 VA	1019297
	User’s Manual	Revision A

Image 14

Powerware UPS 1000 - 2200 user manual Network Transient Protector

Contents

UPS 1000 2200 VA User’s Manual Page Powerware 5125 User’s Manual 1000-2200 VA Table of contents Copyright Requesting a Declaration of Conformity Class a EMC Statements VA Models Special Symbols Powerware 5125 Introduction Powerware Inspecting the Equipment InstallationInstalling the UPS Installation UPS Rear Panels Operation and Configuration Operating Modes Buck and Double Boost Mode Standby ModeNormal Mode UPS Configuration Battery ModeSleep Mode Starting the UPS on Battery Communication Port Turning the UPS OffInitiating the Self-Test Network Transient Protector Network Transient Protector Load Segments VA and 1500 VA Load Segments When to Replace Batteries UPS MaintenanceUPS and Battery Care Storing the UPS and Batteries How to Replace Extended Battery Modules Use the following procedure to replace internal batteries Testing New Batteries Audible Alarms and UPS Conditions TroubleshootingRecycling the Used Battery Silencing an Audible Alarm Alarm or Condition Possible Cause Action 100% Specifications Dimensions W x D x H Weight Battery