
Assembling the 719e Independent Action Climber
Follow the instructions in this section to assemble the 719e Independent Action Climber. It is important to read through the entire procedure before assembling your climber.
To assemble the 719e climber:
1.Prepare Upper Frame for Assembly. Carefully unpack the parts of the 719e climber and open the hardware kit.
Note: For the following steps, hardware callouts are identified by a letter in parentheses. To be sure you are using the correct part, refer to Diagram 2.
Diagram 3 |
Place frame on base. |
Reed switch cable |
Upright support |
(Long tube) |
Lower handrail clamp |
Bolt pad |
Base column support |
(Short tube) |
Lower handrail console |
2.Align Upper Frame Pieces. (Diagram 3) Use the lower console clamp and remove two large, black metal washers (C) and two of the
3.Prepare the lower console clamp. (Diagram 3) Place the lower handrail clamp into position. Align the holes on the lower handrail clamp between the long and short tubes.
Important: As you assemble the climber, be careful not to pinch the reed switch cable that runs through the long tube.
4.Secure Upper Frame Together. (Diagram 3) Place one washer (C) onto each of the two
page 6