20 |
| Operating and Maintaining the P20 Console |
|
|
|
| Event | Description of Event |
| Number |
|
|
|
|
| 22 | No motor pulses at start up |
|
|
|
| 23 | Motor pulses missing after start up |
|
|
|
| 24 | Reduce speed requested, speed is not reducing |
|
|
|
| 26 | Motor pulse width incorrect |
|
|
|
| 27 | Too much drive motor current |
|
|
|
| 28 | Temperature too high |
|
|
|
| 29 | Excessive AC input current |
|
|
|
| 30 | Communications event lower board to upper board |
|
|
|
| 31 | Incorrect Communications event upper board to |
|
| lower board |
|
|
|
| 32 | Communication event upper board to lower board |
|
|
|
| 33 | Incorrect communications event lower board to |
|
| upper board |
|
|
|
| 40 | Lift motion detected |
|
|
|
| 42 | Lift position value out of range |
|
|
|
| 43 | Zero switch not found |
|
|
|
| 44 | |
|
|
|
| 45 | Lift going in the wrong direction |
|
|
|
| 50 | Too much brake (magnet) current |
|
|
|
| 53 | Cannot read target, cannot find home switch |
|
|
|
| 54 | Target pulses lost during operation |
|
|
|
| 55 | Brake home switch activated unexpectedly |
|
|
|
| 60 | Auto Stop sensor failure (treadmill) |
|
|
|
| 61 | Auto Stop not present (treadmill) |
|
|
|
Hour Meter
Tracks the number of hours that a piece of equipment has run. The equipment also tracks elapsed minutes, but the value that displays is rounded up the nearest full hour.
