Precor P/N 300753-201 manual Cable connection points inside EFX base

22Assembling and Maintaining Elliptical Fitness Crosstrainers: EFX 883 / 833 / 823

8.Pull the end of the cable upward through the opening just behind the lift motor, as shown in the previous illustration.

9.Attach the cable to the appropriate connector inside the base of the EFX, as shown in the following illustration and table.

Important: Install coaxial cable using a torque wrench and torque to not exceed 8 lb-in. If a torque wrench is not available, install the coaxial cable using a wrench to “snug + ¼ turn.” It is permissible to use a wrench on the internal nut to aid the tightening process.

Figure 6: Cable connection points inside EFX base

Connect …	To …
The console power	The power connector on the jack panel
cable (red and
black, individual
leads)
The television	The coaxial connector on the jack panel
cable (black and
round)
The Ethernet cable	The eight-connector modular jack on the
(black and flat)	jack panel

10.Repeat steps 7 through 9 for the remaining cables you want to install.