Pride Mobility 1420 Speed Settings, To select a speed setting, Power Accessories, Power Module

V I I . O P E R A T I O N

NOTE: If you still get “ripple up and down of lights”, contact your authorized Pride provider.

NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash, reminding you the batteries need to be charged immediately!

Speed Settings

The Remote Plus speed settings range from 1 to 5.Typically, the slowest speed setting is 1 and the fastest speed setting is 5. The settings are indicated by the number of lights that are lit.

NOTE: The speed settings are preset at the factory. If your authorized Pride provider changes the order of these settings, please make note of these changes. Contact your authorized Pride provider for more information.

To select a speed setting:

1.Press the on/off key to power on the remote.

2.Press the mode key once.

3.To increase chair speed, push the joystick to the right. Each time you push the joystick, you will increase the speed setting.

4.To decrease chair speed, push the joystick to the left. Each time you push the joystick, you decrease the speed setting.

5.Once you select the desired speed setting, press the mode key once to keep the setting or push the joystick in the forward or reverse direction. The chair will resume operation at the selected speed.

NOTE: We recommend that the first few times you operate your power chair, you have your speed on the slowest setting until you become familiar with your new power chair.

Power Accessories

If your power chair is equipped with power accessories such as a power seat or power elevating leg rests, you can operate them through the remote keypad. Contact your authorized Pride provider for information on how to operate these accessories.

Off-board Charger Socket

You may use an off-board charger to charge the power chair batteries through the 3-pin socket located on the front of the controller. See figure 20.The socket may also be used for reprogramming the controller by using a Penny & Giles Programmer, should this be necessary. If you use an off-board charger, the charger current should not exceed 13 amps. Contact your authorized Pride provider for more information.

CAUTION! Only chargers with Neutrik NC3MX plugs should be connected to the off-board charger/ programming socket. See your authorized Pride provider for more information.

Controller Communications Cable

The controller communications cable provides the joystick module with a connection to the power module. See figure 20.

Power Module

Typically, the power module is mounted to the power base. See figure 3. The power module provides a power interface for the joystick module. It routes the battery power to the motors and other powered accessories such as lights and power seats.

Quantum Jazzy 1400 Series Rev D May04 www.pridemobility.com 33