V . C O M F O R T A D J U S T M E N T S

COMFORT ADJUSTMENTS

After becoming familiar with your travel chair’s operation, you may find the need to make some adjustments to increase your comfort, such as seat height, armrest width, foot platform depth, and controller position. Use the steps below to make comfort adjustments.

WARNING! If your Z-Chair was configured by an authorized Pride Provider, please consult the authorized Pride Provider before changing the seat position or making any other adjustment. Some adjustments may degrade your travel chair’s performance and safety by changing its center of gravity.

WARNING! Some Z-Chair components are heavy. Please refer to “Appendix I - Specifications” for specific component weights before you disassemble the Z-Chair.

WARNING! Remove the occupant from the Z-Chair before making any adjustments.

Seat Height Adjustment

You can adjust the seat to two different heights in 1-in. (2.54 cm) increments. Seat height adjustment requires the removal of the battery box.

To change the seat height:

1.Turn off the power to the controller.

2.Disconnect the controller and XLR connectors from the power base.

3.Remove the seat.

4.Remove the battery box.

5.Loosen the quick release fastener. See figure 16.

6.Remove the securement pin from the seat pedestal.

7.Reposition the seat pedestal to the desired height.

8.Reinstall the seat pedestal securement pin.

9.Tighten the quick release fastener. See figure 17.

10.Reinstall the battery box.

11.Reinstall the seat.

12.Reconnect the controller and XLR connectors.

Quick Release Fasteners

SEAT PEDESTAL

QUICK RELEASE

FASTENER

Figure 16. Seat Height Adjustment

The quick release fastener removes excess play in the seat pedestal. See figure 16. The quick release fastener consists of a bolt, a lever, and a nut. See figure 17. The lever has a cam on the end that allows it to clamp into place. The quick release fastener has two states: clamped and unclamped. When the lever is open, the quick release fastener is unclamped. When the lever is closed, the quick release fas- tener is clamped.

To clamp the quick release fastener:

BOLT

CAM

NUT

1.Make sure the lever is in the open position.

2.Turn the nut clockwise until it is snug.

3.Rotate the lever until it is in the fully closed position.

LEVER(OPEN)

LEVER (FULLY CLOSED)

UNCLAMPED

CLAMPED

Figure 17. Quick Release Fastener Operation

Z-Chair

www.pridemobility.com

23

Page 23
Image 23
Pride Mobility INFMAN63121 manual O M F O R T a D J U S T M E N T S, Comfort Adjustments, Seat Height Adjustment