Pride Mobility INFMAN63121 manual When to See An Authorized Pride Provider for Service

V I I . C A R E A N D M A I N T E N A N C E

4.Flip the battery box back over so the handle is up and remove the lid.

5.Remove the red (+) positive and black (-) negative battery leads from each battery.

6.Remove the batteries.

7.Put the new battery batteries back into the battery box (battery terminals up).

8.Reconnect the two (2) battery leads to the battery terminals. Make sure the red lead is connected to the (+) positive terminal and the black lead is connected to the (-) negative terminal.

9.Replace the lid and carefully flip the battery box over so the handle is down.

10.Replace and tighten all the screws that hold the battery box together.

11.Reinstall the battery box back onto the Z-Chair.

When to See An Authorized Pride Provider for Service

The following symptoms could indicate a serious problem with your Z-Chair. If necessary, contact an authorized Pride Provider. When calling, have the model number, serial number, nature of the problem, and the error code if available.

!Motor noise

!Frayed harnesses

!Cracked or broken connectors

!Uneven wear on any of the tires

!Jerky motion

!Pulling to one side

!Bent or broken wheel assemblies

!Does not power up

!Powers up, but does not move

Corrective Maintenance

If the battery condition meter does not light up when you turn on the power:

!Check the harness connections. Make sure they are tight.

!Check the circuit breaker. Reset it if necessary.

!Check the battery connections.

If the above conditions prove normal, you can load test the batteries with a battery load tester. These testers are available at automotive parts stores. Disconnect both batteries before load testing and follow the directions that come with the load tester. If either one of the batteries fails the load test, replace both of them. If your Z-Chair still does not power up, contact an authorized Pride Provider.

34 www.pridemobility.com Z-Chair