I I I . Y O U R Z - C H A I R

 

 

XLR OFF-BOARD CHARGER HARNESS CONNECTOR

 

 

SEAT PEDESTAL

CONTROLLER CONNECTOR

BATTERY BOX

 

 

MANUALFREEWHEEL

 

 

LEVERS

 

CIRCUIT BREAKER

 

 

 

 

BATTERY BOX CHARGER PORT

REAR SECTION

 

 

 

 

FRONT SECTION

Figure 6.The Z-Chair Power Base

Electrical Components

The electrical components are located on the power base. The main circuit breaker is located on the front of the battery box. The controller connector is located on the back of the power base. See figure 6.

Controller Connector: This is where the controller connects to the power base. Each controller uses a different type of cable. Regardless of which type of controller is used, the cable must be secured to the assembly and not allowed to drag on the floor.

Battery Box Charger Port: This enables you to charge the batteries either on the unit or when the battery box is removed from the power base. See VI. “Batteries and Charging.”

Main Circuit Breaker: The main circuit breaker is a safety feature built into your Z-Chair. When the batteries and the motors are heavily strained (e.g., from excessive loads), the main circuit breaker trips to prevent damage to the motors and the electronics. If the circuit trips, allow your Z-Chair to “rest” for approximately one minute. Next, push in the circuit breaker button, turn on the controller, and continue normal operation. If the main circuit breaker continues to trip repeatedly, contact an authorized Pride Provider.

18

www.pridemobility.com

Z-Chair

Page 18
Image 18
Pride Mobility INFMAN63121 manual Electrical Components, Z-Chair Power Base