V I I . A S S E M B L Y
To install the battery well frame:
1.Face the rear of the chair and hold the battery well frame so that the “belly” of the well hangs downward.
2.Position the notches on the front of the battery well frame onto the locating pins on the bottom bar of the front frame. See figure 21.
3.Fit the notch on either side of the rear of the battery well frame onto the locating pin on the right frame assembly and onto the locating pin on the left frame assembly.
4.Make certain that the locking mechanisms snap securely into place.
To install the battery cases:
1.Place the front battery case (with the battery inside) into the front end of the battery well frame.
Note: Make certain that the connectors are facing toward the center.
2.Place the rear battery case (with the batteryinside) into the back end of the battery well frame.
3.Make certain that none of the wiring harnesses or cables are pinched between the battery or the motor controller box and the frame.
4.Connect the
5.Reconnect the left and right motor connectors to their sockets located on the left and right frame assemblies. Be certain to match the left connector to the left motor and the right connector to the right motor (the connectors are labeled left and right).
To install the seat:
1.Pick up the seat by the frame itself (not by the armrests) and slide the locating pins near the back of the frame into the matching slots on the left and rear seat post tower mounts.
2.Slide the pins to the back of the slots. It may be necessary to wiggle the seat slightly from side to side to seat the pins firmly at the back of the slots.
3.Push the front of the seat frame down until both the left and the right frame sides lock into the front seat post tower mounts. See figures 23 and 24.
Figure 20. Fitting the Frames
LOCATING
PINS
Figure 21. The Locating Pins
CONNECTORS
Figure 22. Rear Electronics Tray
US Jazzy 1113/Rev I/Feb03 | www.pridemobility.com | 29 |
