Pride Mobility Jazzy 1113 owner manual Controller Position, Footrest Height, Footrest Angle

V I . C O M F O R T A D J U S T M E N T S

CONTROLLER POSITION

You can position the controller for either left-hand or right-hand use.

To change the controller position:

1.Disconnect the controller harness from the rear battery box. See figure 6.

2.Cut the wire tie that attaches the controller cable to the armrest.

3.Use a 3/16-in. hex key to loosen the setscrew. See figure 14.

4.Slide the controller mounting out of the armrest and place it in the other armrest.

5.Tighten the setscrew.

6.Connect the controller cable to the armrest with a wire tie. See figure 15.

FOOTREST HEIGHT

The footrest height is easily adjusted to one of six different heights, in one-inch increments.

To raise or lower the footrest:

1.Remove the socket cap screw, 5/16-in. nut, and washers from the footrest. See figure 16.

2.Raise or lower the footrest to the desired height.

3.Install the socket cap screw, nut, and two washers into the footrest and tighten.

FOOTREST ANGLE

You can adjust the angle of the footrest with a 3/16-in. hex key. See figure 16.

To adjust the footrest angle:

1.Turn the setscrew clockwise to lower the front of the footrest.

2.Turn the setscrew counterclockwise to raise the front of the footrest.

3.Tighten the setscrew by turning it clockwise.

	FOOTREST ANGLE
USE A WIRE TIE	ADJUSTMENT
	(SCREWLOCATED
TO SUPPORT THE
	UNDERNEATH FOOTREST)
CONTROLLER
CABLE

FOOTREST HEIGHT

ADJUSTMENT

Figure 15. Wire Tie Location Figure 16. Footrest Adjustment

26 www.pridemobility.com US Jazzy 1113/Rev I/Feb03