V I . C O M F O R T A D J U S T M E N T S
13.Reinstall the seat.
14.Reconnect the controller to the power pod.
15.Reinstall the rear shroud.
Seat Position
You can move the seat forward or rearward by changing the extrusion mounting position.
To change the position:
1.Unplugthemotorconnectors,batteryconnector,andcharger inhibit.
2.Removetheseatfromthepowerbase.
3.Removebothextrusionsfromthebottomoftheseat.Seefigure9.
4.Repositiontheextrusionsonadifferentsetofmountingholes.You must move both extrusions the same number of holes either forwardorbackward.Seefigure12.
5.Fastentheextrusionsbackontothebottomoftheseat.
6.Reinstalltheseat.
7.Reconnectthemotorconnector,batteryconnector,andcharger inhibit.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seatback, you can adjust it to four (4) different angles: 90°, 102°, 105°, or 107°.
To adjust the seatback angle:
1.Removetheadjustingscrewsfromeachseathinge.Seefigure13.
2.Settheseatbackatthedesiredangle.
3.Reinstalltheadjustingscrewstoeachseathingeandtighten.
Reclining Seat
If your Jet 10 Ultra is equipped with a reclining seat, you can adjust the seatback angle with the seatback release lever. The lever is located on the right side of the seat base. See figure 14.
To adjust the recline angle:
1.Push down on the seatback release lever.
2.Lean forward or backward to the desired position.
3.Release the lever.
Armrest Width Adjustment
You can change each armrest’s width independently of the other.
Figure 12. Seat Mounting Holes
SEAT |
HINGE |
SEATBACK |
ANGLE |
ADJUSTING |
SCREW |
Figure 13. Seatback Angle Adjustment
NOTE: Changing the armrest width may increase the overall width of your power chair.
Jet 10 Ultra/RevA/Apr04 | www.pridemobility.com | 23 |
