I X . C A R E A N D M A I N T E N A N C E
13.Removethebackbattery.
14.Placeanewbackbatteryonthebatterytray.Makesurethat
theterminalsarefacingforward.
15. Fastenthereusablestraparoundthebackbattery.
16.Connectthewiringharnessestothebackbattery.Seefigures 26 and 27.
WARNING! Prevent injury. Use only the |
|
quick disconnect harness supplied with |
|
the Jet 10 Ultra. It has a thermal fuse |
|
on each lead. | Figure 27. Battery Wiring Diagram |
17. Placeanewbatteryinthefrontofthebatterytray.Makesurethattheterminalsarefacingbackward.
WARNING! Prevent injury. Make sure you tighten the fasteners so that the connections are secure.
18.Fastenthereusablestraparoundthefrontbattery.
19.Connectthewiringharnessestothefrontbattery.Seefigures26and27.
20.Slidethebatterytraybackintothepowerbase.
NOTE: Make sure that the power pod is out of the way when reinstalling the batteries.
21.Reinstall the foot platform.
22.Reconnect the battery connector.
23.Reinstall the rear shroud and tighten the fasteners.
24.Charge the batteries. See VII. “Batteries and Charging.”
When to See Your authorized Pride Provider for Service
The following symptoms could indicate a serious problem with your power chair. If necessary, contact your authorized Pride Provider. When calling, have the model number, serial number, nature of the problem, and the error code if available.
νMotor noise
νCracked or broken connectors
νJerky motion
νBent or broken wheel assemblies
νPowers up, but does not move
νFrayed harnesses
νUneven wear on any of the tires
νPulling to one side
νDoes not power up
Corrective Maintenance
If the battery condition meter does not light up when you turn on the power:
νCheck the harness connections. Make sure they are tight.
νCheck the circuit breaker. Reset it if necessary.
νCheck the battery connections.
If the above conditions prove normal, you can load test the batteries with a battery load tester. These testers are available at automotive parts stores. Disconnect both batteries before load testing and follow the directions that come with the load tester. If either one of the batteries fails the load test, replace both of them. If your power chair still does not power up, contact your authorized Pride Provider.
Jet 10 Ultra/RevA/Apr04 | www.pridemobility.com | 39 |
