V I . C O M F O R T A D J U S T M E N T S
3.Turn the setscrew clockwise to lower the front of the foot platform.
Controller Position
SETSCREW
WARNING! Do not place the controller cable so that it can be pinched in the seat frame or the power base frame.
To change the controller position:
1.Turn the rear shroud fasteners
2.Remove the rear shroud.
3.Unplug the motor connectors, the charger inhibit, and the battery connector from the power pod. See figure 6.
4.Cut the wire tie(s) that attaches the controller cable to the armrest.
5.Flip up the armrest and loosen the setscrew. See figure 18.
6.Slide the controller out of the armrest.
7.Loosen the setscrew in the other armrest.
8.Place the controller in the other armrest.
9.Tighten the setscrew to secure the controller.
10.Use a wire tie to secure the controller cable to the armrest.
11.Plug the motor connectors, the charger inhibit, and the battery connector into the power pod. See figure 6.
12.Reinstall the rear shroud and tighten the fasteners.
Swing-away Footrests
To rotate the SFRs:
1.Push in the release lever. See figure 19.
2.Rotate the SFRs.
To adjust the SFR length:
1.Remove the two adjustment screws from the side of each footrest extension. See figure 19.
2.Slide the footrest up or down to the desired length.
3.Reinstall the two adjustment screws.
Figure 17. Bottom of Footrest
SETSCREW
Figure 18. Underside of Armrest
SFR RELEASE LEVER
FOOTREST
EXTENSION
FOOTREST
ADJUSTMENT SCREWS
Elevating Leg Rests (Optional) | Figure 19. |
Elevating Leg Rests (ELRs) offer an infinite range of adjustment for the leg angle and a footrest adjustment range of
Jet 10 Ultra/RevA/Apr04 | www.pridemobility.com | 25 |
