Printronix ANSI Printer manual Flash Memory Message Guide, Message Explanation Required Action

Flash Memory Message Guide

Flash Memory Message Guide

Message	Explanation	Required Action
CLEARING PROGRAM	The program successfully	None
FROM FLASH	loaded into printer RAM and
	the checksum matched. The
	old program is now being
	deleted from flash memory.
DIAGNOSTIC PASSED	The printer passed its	None
	memory and hardware
	initialization tests.
ERROR: DC PROGRAM	Printer cannot find the data	1. Download the program
NOT VALID	controller program or the	again.
	validation checksum is	2. If the message occurs
	corrupt.
		again, replace the flash
		memory.
ERROR: DRAM AT	The printer found a defective	Replace the DRAM.
ADDRESS XXXXXXXX	memory location.
ERROR: EC PROGRAM	Printer cannot find the engine	1. Download the program
NOT VALID	controller program or the	again.
	validation checksum is	2. If the message occurs
	corrupt.
		again, replace the flash
		memory.
ERROR: EC STOPPED AT	Hardware fault in the engine	Replace the CMX controller
STATE XXXX	controller.	board.
ERROR: FLASH DID NOT	The printer could not find any	1. Download the program
PROGRAM	flash memory.	again.
		2. If the message occurs
		again, replace the flash
		memory.
ERROR: FLASH NOT	The printer could not find any	Install flash memory before
DETECTED	flash memory.	attempting to download this
		program.
ERROR: NO DRAM	The printer could not find any	Check DRAM on CMX. If
DETECTED	DRAM.	present, reseat DRAM. If
		missing, install DRAM.
ERROR: NVRAM FAILURE	The non-volatile memory has	Replace the CMX controller
	failed.	board. (Do NOT attempt to
		replace NVRAM.)
ERROR: PROGRAM NEEDS	The printer requires more	Add DRAM or use a smaller
MORE DRAM	DRAM memory in order to run	emulation program.
	the downloaded program.

19