ProForm PCTL69100 Assembly requires two people, Extension Leg and thread the Handrail Bolt

ASSEMBLY

Assembly requires two people.	Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.		Assembly requires the included allen wrench
and your own phillips screwdriver	and rubber mallet	.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1.With the help of a second person, carefully raise the Uprights (82) until the treadmill is in the position shown.

2. Remove the Latch Knob (110) from the Latch Pin (114).

Make sure that the Latch Pin Collar (112) and the Spring

(111)are on the Latch Pin (114) as shown. Insert the Latch Pin into the Storage Latch (77).

Tighten the Latch Knob (110) back onto the Latch Pin (114).

3.See drawing 3a. Press a Handrail Insert (102) into the lower end of a Handrail (85). Hold an Extension Leg

(103)against the lower end of the Handrail. Insert a Handrail Bolt (78) with a Handrail Washer (36) into the

Extension Leg and thread the Handrail Bolt		three or
four turns	into the Handrail. Notice the angle of the

Handrail and insert the Handrail Bolt and Washer at the same angle (see drawing 3b).

Attach a Handrail Insert (102) and an Extension Leg (103) to the other Handrail (85) in the same way.

1
		82
2
110
77
	111	112
		114
3a	3b
85
102		85
	103
	103	36
36		78
78

6