14.Note: This step may be easier if the resistance system is tipped over forward.
Wrap the wire found inside the Rear Frame (10) around the end of the Long Cable (42). Pull the Long Cable through the Rear Frame and out of the Swivel Arm (12). Have a second person hold the cable end until step 15 is completed. Discard the wire.
Hold a 90mm Pulley (38) next to the Long Cable (42) as shown. Insert an M10 x 132mm Button Bolt (69) into a Guard (37), a Cable Trap (39), the Pulley, an M10 Washer (59), an 8mm Spacer (41), another Guard (37), and another 8mm Spacer (41). Note: The end of the Button Bolt must be flush with the edge of the last Spacer. Make sure that the Cable Trap is oriented to hold the Cable in the groove of the Pulley. The flat edge of each Guard must be toward the Rear Frame (10).
See the inset drawing. Insert the 90mm Pulley
(38)into the Rear Frame (10). Push the M10 x 132mm Button Bolt (69) through the Rear Frame and the Right Upright (7). Tighten an M10 Nylon Locknut (56) onto the Button Bolt.
Tighten the M10 Nylon Locknuts (56) used in steps 3 and 7.
15.Make sure that the Long Cable (42) is below the rod in the Swivel Arm (12).
Attach a 90mm Pulley (38) inside the Swivel Arm (12), under the Long Cable (42), with an M10 x 51mm Button Bolt (74), two M10 Washers (59), two 5mm Spacers (76), and an M10 Nylon Locknut (56).
16.Attach the Backrest (30) to the Upright Base (5) and the Uprights (6 and 7) with four M6 x 76mm Screws (64) and four M6 Washers (60).
14 | 69 |
|
|
|
|
|
|
|
|
| |
| 37 |
|
|
|
|
| 39 |
|
|
| |
| 38 |
|
|
| |
|
| 59 |
|
|
|
|
| 41 |
|
|
|
|
| 37 | 10 |
|
|
|
| 41 |
|
| |
|
|
|
| 12 | |
|
|
|
|
| |
|
| 42 |
|
|
|
|
|
|
|
| Wire |
| 69 | 10 |
|
|
|
| 38 |
|
|
|
|
| 7 |
|
|
|
|
56 |
|
|
|
|
|
15 |
|
|
|
| 56 |
|
|
|
|
| |
|
|
|
|
| 76 |
| Rod |
|
|
| 59 |
|
|
|
|
| |
| 76 |
|
|
|
|
74 | 59 |
| 12 |
|
|
|
|
|
|
| |
|
|
| 38 |
|
|
| 42 |
|
|
|
|
16 | 7 |
| 6 | 60 |
|
|
| 64 | |||
|
|
|
|
| |
|
|
|
| 60 | 64 |
|
|
|
|
| |
30 |
|
|
|
| 60 |
|
|
|
|
| |
|
|
| 5 |
|
|
11
