ASSEMBLY
Make Assembly Easier
Everything in this manual is designed to ensure that the resistance system can be assembled successfully by almost anyone. Most people find that by setting aside plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the following information and instructions:
•Assembly requires two persons.
•Because of its weight and size, the resistance system should be assembled in the location where it will be used. Make sure that there is enough clearance to walk around the resistance system as you assemble it.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•As you assemble the resistance system, make sure all parts are oriented as shown in the draw- ings.
•For help identifying small parts, use the PART IDENTIFICATION CHART.
The included hex key 
and grease, and the following tools (not included) may be required for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
Assembly will be more convenient if you have a socket set, a set of
1. | 1 |
|
|
Before beginning assembly, make sure that |
|
| |
you understand the information in the box |
|
|
|
above. To identify small parts, use the | 4 |
|
|
PART IDENTIFICATION CHART on page 5. |
|
| |
Attach three Plastic Feet (1) to the Base (2) with |
|
| 2 |
three M4 x 16mm Screws (61). |
|
| |
|
|
| |
Attach the Base Cover (4) to the Base (2) with |
|
|
|
two M4 x 50mm Screws (66). |
|
|
|
|
| 1 | 1 |
|
| 61 | |
|
| 61 | |
|
|
| |
| 66 |
| 1 |
|
|
| 61 |
|
|
| 66 |
| 6 |
|
|
