13. Apply a thin film of grease to one of the Pedal Leg Axles | 13 |
| |
(32) and to the faces of the two Pedal Leg Bushings |
| ||
|
| ||
(33) in the Left Pedal Leg (14). |
|
| |
Next, slide an M8 Washer (88) and a Pedal Leg Cover |
|
| |
(31) onto an M8 x 23mm Shoulder Screw (115), and | 11 | 12 | |
turn the Shoulder Screw a few turns into the Pedal Leg | |||
| 88 | ||
Axle (32). |
| 31 | |
While another person holds the front end of the Left | 31 | 115 | |
88 | |||
Pedal Leg (14) inside of the bracket on the Left Upper | |||
| |||
Body Arm (11), insert the Pedal Leg Axle (32) into both |
| ||
|
| ||
parts. Next, slide an M8 Washer (88) and a Pedal Leg | 115 |
| |
Cover (31) onto another M8 x 23mm Shoulder Screw |
| ||
Grease |
| ||
(115), and turn the Shoulder Screw a few turns into the | 32 | ||
Pedal Leg Axle. Tighten both Shoulder Screws. |
|
|
Repeat this step to attach the Right Pedal Leg (not shown) to the Right Upper Body Arm (12).
| 14 | |
14. Lift the latch on the underside of the Left Pedal Leg | 14 | |
(14), and set the Left Pedal Leg on the left Crank | ||
| ||
Bushing Sleeve (43). Release the lever, and make sure |
| |
that the Left Pedal Leg is securely connected to the |
| |
Crank Bushing Sleeve. |
| |
Connect the Right Pedal Leg (not shown) in the same | 14 | |
way. | Latch | |
| ||
See step 5. Tighten the M8 x 69mm Button Bolt (80) | 43 | |
and the two M8 x 23mm Button Screws (84). | ||
|
15.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.
10
