7.Remove the band securing the Upright Wire (73) to the right Upright (85). Have a second person hold the console assembly near the right Upright. Connect the Upright Wire (73) to the wire harness on the console assembly. See the inset draw- ing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNEC-
TORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Then, insert the connectors into the right Upright (85).
8.Remove the band securing the TV Cable (112) to the left Upright (85). Connect the TV Cable to the cable extending from the console assembly. Then, insert the cables into the left Upright.
Next, insert the brackets on the Handrails (70) into the Uprights (85). Make sure that no wires are pinched.
9.Attach the console assembly to the Uprights
(85) with four 3/8" x 1 1/4" Bolts (72) and four 3/8" Star Washers (67) (only one side is shown).
Start all four Bolts before tightening any of them.
7 |
|
| |
Console |
|
| |
Assembly |
|
| |
73 |
| 73 | |
85 | Wire | ||
Wire | |||
| Harness | ||
|
| Harness |
8 |
|
|
|
| Bracket |
Console | Cable | 70 |
Assembly |
| 112 |
|
| 85 |
9 |
|
|
|
85 | 67 | 72 | Console |
| |||
|
| Assembly |
10
