TROUBLESHOOTING
Most treadmill problems can be solved by following the instructions below. If further assistance is
needed, please call our Customer Service Department
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 10). Use only a
b. Make sure that the key is fully inserted into the console.
c.Check the reset/off circuit breaker located on the frame near the power cord. If the breaker protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the breaker back in.
PROBLEM: The power turns off during use
SOLUTION: a. Check the reset/off circuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.
c. Remove the key from the console and then reinsert it.
c
Off Reset
PROBLEM: The displays of the console do not function properly |
|
|
| ||
SOLUTION: | a. Remove the key from the console and | UNPLUG THE | a |
| |
| POWER CORD. | With the help of another person, |
|
| |
|
|
| 6 | ||
| carefully tip the Base (109) down as shown. Remove |
|
| ||
|
|
|
| ||
| the two 3/4”Screws (6). Note: A phillips screwdriver |
|
|
| |
| with at least a 5” shaft is required. |
|
|
| |
|
|
|
|
| 109 |
| With the help of another person, carefully raise the |
|
|
| |
| Right Upright (82) and the Left Upright (69) as shown. | 69 | 39 | ||
| Carefully pivot the Hood (39) off. |
|
| 82 | |
26
