ProForm PFTL51330 user manual Assembly, Wire cutters, Harness

ASSEMBLY

Assembly requires two persons.		Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included allen wrenches		and your own phillips screwdriver	,
wire cutters	, rubber mallet	, and adjustable wrench	.

For help identifying assembly hardware, refer to the drawings below. Note: The assembly hardware and other small parts are packaged in separate part bags. Do not open the part bags until instructed to do so. If a part is not found in the part bags, check to see if the part has been preattached.

Pulse Bar Screw	3/4” Screw (6)–10			1/2” Ground
(68)–4		3/4” Tek Screw (47)–6		Screw (114)–1
					1/4” Star Washer
Wheel Bolt (107)–2					(92)–4
	5/16” x 3 1/2” Bolt (93)–4			1” Bolt (71)–4
	3/8” x 3 1/2” Bolt (81)–2				5/16” Star
				Wheel Nut (21)–2
					Washer (104)–4
1. With the help of another person, carefully tip the tread-			1	83
mill onto its left side. Identify the Right Upright (82); the
indicated bracket on the Right Upright overhangs on the
left side as shown. Make sure that there are two U-Nuts
(105) in the lower end of the Right Upright (see the inset
drawing). Feed the Wire Harness (83) into the lower end					82
of the Right Upright, and pull the Wire Harness out of the
hole in the upper end of the Right Upright. Note: There			Bracket		109
may be a tie on the Wire Harness to help you pull it out
of the hole.
Open part bag A.	Attach the Right Upright (82) to the			Notch
right side of the Base (109) with two 5/16” x 3 1/2” Bolts					104
(93) and two 5/16” Star Washers (104).		Do not tighten		99
the Bolts yet. Be careful not to damage the Wire
Harness (83).	Attach the Left Upright (not shown) to the			82	93
left side of the Base in the same way. Note: There is not
a wire harness on the left side.
Press the two Base Endcaps (99) into the Base (109)
(only one is shown). Make sure that the notch in each				105
Base Endcap is at the top as shown. Note: The Base
Endcaps may be preassembled.
			6