Locate the Reed Switch (24) and the Magnet (18) on |
| |||
the left side of the Pulley | (120). Turn the Pulley until |
| ||
the Magnet is aligned with | the Reed Switch. | Make | ||
sure | that the gap between the | Magnet and the |
|
|
Reed | Switch is about 1/8”. | If necessary, loosen the | ||
Screw (25) and move the Reed Switch slightly. Retighten the Screw. Reattach the Hood. Make sure the Screws are return to the correct holes (see step A). Run on the treadmill for a few minutes to check for a correct speed reading.
1/8”
25
24
Top
View
120
18
PROBLEM: The walking belt slows when walked on |
|
|
|
| |
SOLUTION: | a. Use only a |
| |||
| b. If the walking belt is overtightened, treadmill perfor- |
| b | ||
| mance may decrease and the walking belt may be |
| |||
| permanently damaged. Remove the key and | UN- |
|
| |
| PLUG THE POWER CORD | . Using the included allen |
|
| |
| wrench, turn both rear roller adjustment bolts counter- |
|
|
| |
| clockwise 1/4 of a turn. When the walking belt is prop- |
|
|
| |
| erly tightened, you should be able to lift | the edges | of |
| |
| the walking belt 3 to 4 inches off the walking platform. |
|
|
| |
| Be careful to keep the walking belt centered. Plug in |
| Rear Roller Adjustment Bolts |
| |
| the power cord, insert the key, and run the treadmill |
|
| ||
| for a few minutes. Repeat until the walking belt is |
|
|
| |
| properly tightened. |
|
|
|
|
PROBLEM: The walking belt is |
|
| ||
SOLUTION: | a. If the walking belt is |
| ||
| and UNPLUG THE POWER CORD | . If the walking | ||
| belt has shifted to the left, | use the allen wrench to |
| |
| turn the left rear roller bolt clockwise 1/2 of a turn; | if | ||
| the walking belt has shifted to the right, |
| turn the | |
| bolt counterclockwise 1/2 of a turn. Be careful not to |
| ||
| overtighten the walking belt. Plug in the power cord, |
| ||
| insert the key, and run the treadmill for a few minutes. |
| ||
| Repeat until the walking belt is centered. |
|
| |
| b. If the walking belt slips when walked on, first remove |
| ||
| the key and | UNPLUG THE POWER CORD | . Using | |
| the allen wrench, turn both rear roller bolts clockwise |
| ||
| 1/4 of a turn. When the walking belt is correctly tight- |
| ||
| ened, you should be able to lift each side of the walk- |
| ||
| ing belt 3 to 4 inches off the walking platform. Be |
| ||
| careful to keep the walking belt centered. Plug in the |
| ||
| power cord, insert the key, and walk on the treadmill |
| ||
| for a few minutes. Repeat until the walking belt is |
| ||
| properly tightened. |
|
| |
a
b
27
