Onkyo TX-NR717 En-18, Connecting Onkyo RI Components, System On/Auto Power On, Direct Change

Note

*1 When the USB input is selected, you can input video signals from the VIDEO jack. Video signals input from VIDEO will be output from the MONITOR OUT V and HDMI output jacks.

*2 Do not connect the AV receiver’s USB port to a USB port on

your computer. Music on your computer cannot be played through the AV receiver in this way.

*3 Only the front-panel USB input is compatible with iPod/iPhone.

*4 Connect a turntable (MM) that has a built-in phono preamp to TV/CD IN, or connect it to PHONO IN with the phono preamp turned off. If your turntable (MM) doesn’t have a phono preamp, connect it to PHONO IN. If your turntable has a moving coil (MC) type cartridge, you’ll need a commercially available MC head amp or MC transformer to connect to PHONO IN. See your turntable’s manual for details.

If your turntable has a ground wire, connect it to the AV receiver’s GND screw. With some turntables, connecting the ground wire may produce an audible hum. If this happens, disconnect it.

*5 When you connect your personal computer to PC IN and select the PC input selector, the video of the personal computer is output from the HDMI outputs. However, if you have assigned the HDMI inputs to the PC input selector, the AV receiver will

Connecting Onkyo RI Components

1	Make sure that each Onkyo component is connected
	with an analog audio cable (connection E in the
	hookup examples) (➔ page 17).
2	Make the uconnection (see the illustration).
3	If you’re using an RI Dock, or cassette tape deck,
	change the Input Display (➔ page 46).

With u(Remote Interactive), you can use the following special functions:

■ System On/Auto Power On

When you start playback on a component connected via

u, while the AV receiver is on standby, the AV

receiver will automatically turn on and select that

component as the input source.

■ Direct Change

When playback is started on a component connected via

u, the AV receiver automatically selects that

component as the input source.

e.g., cassette tape deck

RI Dock

Note

Connections

R L

ANALOG

AUDIO OUT

R L

ANALOG

AUDIO OUT

output signals received from the HDMI inputs instead of signals from PC IN. To have the signals output from PC IN, select “- - - - -” for “PC” in the “HDMI Input” setting

(➔ page 53).

•With connection C, you can enjoy Dolby Digital and DTS. (To listen in Zone 2/3 as well, use C and E.)

•With connection E, you can enjoy audio from external components while you are in Zone 2/3.

•With connection E, if your Blu-ray Disc/DVD player has both the main stereo and multichannel outputs, be sure to connect the main stereo.

■ Remote Control

You can use the AV receiver’s remote controller to

control your other u-capable Onkyo components,

pointing the remote controller at the AV receiver’s

remote control sensor instead of the component. You

must enter the appropriate remote control code first

(➔ page 77).

•Use only ucables for uconnections. ucables are supplied with Onkyo components.

•Some components have two ujacks. You can connect either one to the AV receiver. The other jack is for connecting additional u-capable components.

•Connect only Onkyo components to ujacks. Connecting other manufacturer’s components may cause a malfunction.

•Some components may not support all ufunctions. Refer to the manuals supplied with your Onkyo components.

•While Zone 2/3 is on, the System On/Auto Power On and Direct Change ufunctions do not work.

En-18