Onkyo TX-NR717 En-32, Auto tuning mode, Manual tuning mode, Tuning into stations by frequency

Tuning into Radio Stations

■Auto tuning mode

1	Press TUNING MODE so that the AUTO indicator
	lights on the AV receiver’s display.
2	Press TUNING q/w.
	Searching stops when a station is found.

When tuned into a station, the TUNED indicator lights. When tuned into a stereo FM station, the FM STEREO indicator lights as shown.

TUNED

AUTO

FM STEREO

Tip

•Tuning into weak FM stereo stations

If the signal from a stereo FM station is weak, it may be impossible to get good reception. In this case, switch to manual tuning mode and listen to the station in mono.

■Manual tuning mode

In manual tuning mode, FM stations will be in mono.

1	Press TUNING MODE so that the AUTO indicator
	goes off on the AV receiver’s display.
2	Press and hold TUNING q/w.
	The frequency stops changing when you release the
	button.

Press the buttons repeatedly to change the frequency one step at a time.

■Tuning into stations by frequency

You can tune into AM and FM stations directly by entering the appropriate frequency.

1 On the remote controller, press TUNER repeatedly to select “AM” or “FM”, followed by D.TUN.

(Actual display depends on the country.)

2 Within 8 seconds, use the number buttons to enter the frequency of the radio station.

For example, to tune to 87.5 (FM), press 8, 7, 5 or 8,

7, 5, 0.

If you have entered the wrong number, you can retry after 8 seconds.

Presetting AM/FM Stations

You can store a combination of up to 40 of your favorite AM/FM radio stations as presets.

1	Tune into the AM/FM station that you want to store
	as a preset.
	See the previous section.
2	Press MEMORY.
	The preset number flashes.

(Actual display depends on the country.)

3 While the preset number is flashing (about 8 seconds), use PRESET e/rto select a preset from 1 through 40.

En-32

Turning On & Basic Operations

4 Press MEMORY again to store the station or channel.

The station or channel is stored and the preset number stops flashing.

Repeat this procedure for all of your favorite AM/FM radio stations.

■Selecting Presets

1 To select a preset, use PRESET e/ron the AV

receiver, or the remote controller’s CH +/–.

Tip

•You can also use the remote controller’s number buttons to select a preset directly.

■Deleting Presets

1	Select the preset that you want to delete.
	See the previous section.
2	While holding down MEMORY, press TUNING
	MODE.

The preset is deleted and its number disappears from the AV receiver’s display.