Onkyo TX-NR717 En-71, Controlling Multi Zone Components, Operating on the AV receiver, 8RECEIVER

Note

• The volume of Zone 2/3 must be set on the Zone 2/3 amplifier.

Zone 2 12V Trigger

When Zone 2 is turned on, the output from the ZONE 2 12V TRIGGER OUT jack goes high (+12 V and max. 150 mA for Zone 2). Connecting this jack to a 12-volt trigger input on a component in Zone 2 will make that component turn on or off as the AV receiver turns on or off the Zone 2.

Controlling Multi Zone Components

■Operating on the AV receiver

Input selector buttons

1

2

To turn on Zone 2/3 and select an input source, press ZONE 2 or ZONE 3 followed by an input selector button within 8 seconds.

Zone 2/3 turns on, the Z2 or Z3 indicator lights on the AV receiver’s display.

Tip

• The Zone 2 trigger output goes high (+12 V).

To select the same source as the main room’s, press ZONE 2 or ZONE 3 twice. “Zone 2 Selector:

Source” or “Zone 3 Selector: Source” appears on the

AV receiver’s display.

To turn off Zone 2/3, press ZONE 2 or ZONE 3 followed by 8ON/STANDBY within 8 seconds.

The zone is turned off.

		Advanced Operations
1	Press ZONE2 or ZONE3, then point the remote
	controller at the AV receiver and press
	8RECEIVER.
	Zone 2/3 turns on, the Z2 or Z3 indicator lights on the
	AV receiver’s display.
	Tip
	• The Zone 2 trigger output goes high (+12 V).
2	To select an input source for Zone 2/3, press
	ZONE2 or ZONE3, followed by an INPUT
	SELECTOR button.
3	To turn off Zone 2/3, press ZONE2 or ZONE3,
	followed by 8RECEIVER.
	The zone is turned off.

ZONE 2	ZONE 3	MASTER VOLUME	Tip
			• The Zone 2 trigger output goes low (0 volts).
			■ Operating on the remote controller
			To control Zone 2/3, you must press ZONE2 or ZONE3
			on the remote controller first.
8ON/STANDBY			8RECEIVER
Tip			INPUT
			SELECTOR

• The Whole House Mode function shares the input source of main
room with Multi Zone (➔ page 47).	ZONE2	MUTING
	ZONE3	VOLq/w

En-71

	Tip
	• The Zone 2 trigger output goes low (0 volts).
Adjusting the Volume for Zones
■ Operating on the remote controller
1	Press ZONE2 or ZONE3.
2	Use VOL q/w.

■Operating on the AV receiver

1	Press ZONE 2 or ZONE 3 (the Z2/Z3 indicator on
	the display flashes).
2	Use MASTER VOLUME control within 8 seconds.

If your Zone 2/3 speakers are connected to a receiver or integrated amplifier in Zone 2/3, use its volume control to adjust the volume.