Onkyo TX-NR717 instruction manual En-63

*1

*2

*3

*4

*5

*6

*7

■Picture Mode*1*3

`Custom:

All settings can be performed manually.

`Cinema:

Select when the picture source is a movie or alike.

`Game:

Select when the video source is a game console.

`Through:

Does not adjust picture quality (changes resolution).

`Direct:

Does not adjust picture quality (does not change resolution). The video coming from an analog input and output by the HDMI output is processed in the same way as “Through”.

With “Picture Mode”, you can change the following settings to be suitable for the movie or game screen by one operation; “Game Mode”, “Film Mode”, “Edge Enhancement”, “Noise Reduction”, “Brightness”, “Contrast”, “Hue”, “Saturation” or “Color

Temperature”.

■Game Mode*4*5*6

`Off

`On

If video signal delay occurs during playback on a video component (i.e., game console), select the corresponding input source and set the “Game Mode” setting to “On”. The delay will decrease but in return the picture quality will become poor.

■Film Mode*4*6

`Video:

“Film Mode” detection is not applied and the input signal is handled as a video source.

`Auto:

Detects whether the input signal is a video or a movie. If it is a movie, the appropriate conversion is applied.

The AV receiver will adjust to the picture source, automatically converting it to the appropriate progressive

signal and reproducing the natural quality of the original picture.

■Edge Enhancement*4*6*7

`Off

`Low

`Mid

`High

With this setting, you can make the picture appear sharper.

■Noise Reduction*4*6*7

`Off

`Low

`Mid

`High

With this setting, you can reduce noise appearing on the screen. Select the desired level.

■Brightness*1*4*6

`–50 to 0 to +50

With this setting, you can adjust the picture brightness. “–50” is the darkest. “+50” is the brightest.

■Contrast*1*4*6

`–50 to 0 to +50

With this setting, you can adjust contrast. “–50” is the least. “+50” is the greatest.

■Hue*1*4*6

`–50 to 0 to +50

With this setting, you can adjust the color hue between “–50” and “+50”.

■Saturation*1*4*6

`–50 to 0 to +50

With this setting, you can adjust saturation. “–50” is the weakest color. “+50” is the strongest color.

■Color Temperature*4*6

`Warm

`Normal

`Cool

En-63

Advanced Operations

With this setting, you can adjust the color temperature.

Note

•“Picture Adjust” cannot be used when:

–The NET input selector is selected, or

–“Monitor Out” is set to “Sub” (➔ page 53).

This procedure can also be performed on the remote controller by using the Quick Setup (➔ page 48).

When a 3D video source is input, “Wide Mode” is fixed to “Full”.

When “Metadata Compatible” is enabled (➔ page 57), “Picture Mode” is fixed to “Direct”.

When the “Picture Mode” setting is set to anything other than “Custom”, this setting cannot be used.

If the “Resolution” setting is set to “4K Upscaling” (➔ page 53), this setting is fixed at “Off”.

Press CLR if you want to reset to the default value.

If the “Game Mode” setting is set to “On”, this setting is fixed at “Off”.