Onkyo TX-NR717 En-49, Using the Audio Settings of Quick Setup, Tone Control, Speaker Levels

Note

*1 • The video preview is not displayed when:

–HDMI IN 5/6/7 is the current HDMI input source, or

–No signal is present on the current input source.

•The video of the currently-selected input is displayed on the main screen, not on a preview thumbnail.

*2 “Dynamic EQ” and “Dynamic Volume” cannot be selected when any of the THX listening modes is selected, with “Loudness Plus” set to “On” or “Preserve THX Settings” set to “Yes” (➔ page 57).

*3 • When the “Monitor Out” setting is set to “Sub”, “Video” cannot be selected (➔ page 53).

•This setting cannot be used with the NET input selector. *4 Only when you have selected “Custom” in the “Picture

Mode” (➔ page 63), pressing ENTER allows you to adjust the following items via the Quick Setup: “Brightness”, “Contrast”, “Hue” and “Saturation”. Press RETURN to return to the “Picture Mode” setting.

*5 Depending on the input source and listening mode, not all channels shown here output the sound.

*6 • This setting is not available in either of the following cases:

–The “Audio TV Out” setting is set to “On” (➔ page 67).

–“HDMI Control(RIHD)” is set to “On” (➔ page 67) and you’re listening through your TV speakers.

Using the Audio Settings of Quick Setup

You can change various audio settings from the Quick Setup (➔ page 48).

Note

•These settings are not available in either of the following cases:

–The “Audio TV Out” setting is set to “On” (➔ page 67).

–“HDMI Control(RIHD)” is set to “On” (➔ page 67) and you’re listening through your TV speakers.

Tone Control

■Bass

`–10dBto 0dB to +10dB in 2 dB steps

You can boost or cut low-frequency sounds output from the front speakers.

■Treble

`–10dBto 0dB to +10dB in 2 dB steps

You can boost or cut high-frequency sounds output from the front speakers.

You can adjust the bass and treble for the front speakers, except when the Direct, Pure Audio or THX listening mode is selected.

Operating on the AV receiver

1	Press TONE repeatedly to select either “Bass” or
	“Treble”.
2	Use – and + to adjust.

En-49

Advanced Operations

Speaker Levels

■Subwoofer Level

`–15.0dBto 0.0dB to +12.0dB in 0.5 dB steps

■Center Level

`–12.0dBto 0.0dB to +12.0dB in 0.5 dB steps

You can adjust the volume of each speaker while listening to an input source.

These temporary adjustments are cancelled when the AV receiver is set to standby. To save the setting you made here, go to “Level Calibration” (➔ page 56) before setting the AV receiver to standby.

Note

•You cannot use these function while the AV receiver is muted.

•These settings cannot be used while a pair of headphones is connected.

•Speakers that are set to “No” or “None” in

“Speaker Configuration” (➔ page 55) cannot be adjusted.