8.Tighten the two 3/8” x 3 1/2” Bolts (81). Apply a Cap Decal (113) to each Crossbar Cap (84).

7

84

81

113

9.Remove the knob from the pin. Make sure that the collar and the spring are on the pin as shown. Insert the pin into the Latch Housing (75) and tighten the knob back onto the pin.

With the help of another person, raise the Frame (54) about halfway to the vertical position. While the other person holds the Frame, hold the Latch Housing (75) against the inside of the Frame. Thread two 3/4” Screws

(6) several turns into the Latch Housing and the Frame.

Press the Latch Cover (12) into the left side of the Frame (54). See the inset drawing. Make sure that the notch in the Latch Cover is positioned over the left Foot Rail (2) as shown.

Align the pin with the hole in the Left Handgrip (76) by sliding the Latch Housing (75) up or down. Make sure that the pin can be inserted fully into the hole. Hold the Latch Housing in place and tighten the two 3/4” Screws

(6).Be careful not to overtighten the Screws.

9

 

 

 

 

 

Hole

 

 

 

 

76

 

 

Pin

Collar

 

 

 

 

12

 

75

 

 

 

 

54

 

6

 

 

 

Spring

2

Notch

 

Knob

 

12

 

 

 

54

 

 

10. Make sure that

all parts are properly tightened before you use the treadmill.

Note: Extra hardware may

be included.

Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the

 

walking belt

(see page 27). To protect the floor or carpet, place a mat under the treadmill.

 

9

Page 9
Image 9
ProForm PFTL51330 user manual Be careful not to overtighten the Screws