3.Attach a Wheel (86) to the Base (85) with an Do M10 x 50mm Bolt (27) and an M10 Nut (33). not overtighten the Nut; the Wheel must turn freely.
4.Identify the Right Upright (78) and the Right Upright Spacer (80), which are marked with stickers.
Insert the Wire Harness (77) through the Right Upright Spacer (80) as shown. Then, set the Right Upright Spacer on the Base (85).
Have a second person hold the Right Upright (78) near the Base (85). See the inset drawing. Tie the wire tie in the Right Upright securely around the end of the Wire Harness (77). Then, pull the other end of the wire tie until the Wire Harness is routed completely through the Right Upright.
3 |
|
|
|
27 |
|
|
|
33 | 86 | 85 |
|
|
|
| |
4 |
| Wire |
|
|
| Tie | 78 |
77 |
|
| |
| 85 | 77 | |
|
| 80 |
| 78 |
77 | Wire |
Tie |
5. Hold a Bolt Spacer (79) inside the lower end of | 5 | 5 |
the Right Upright (78). Insert an M10 x 96mm | ||
Bolt (5) with an M10 Star Washer (8) into the |
| 78 |
Right Upright and the Bolt Spacer. Repeat this |
| |
step with a second Bolt Spacer (79), M10 x |
|
|
96mm Bolt (5), and M10 Star Washer (8). |
| 8 7 |
Hold the Right Upright (78) against the Right |
| |
Upright Spacer (80). Be careful not to pinch |
| 79 |
the Wire Harness (77). Tighten the M10 x |
| |
96mm Bolts (5) until the heads of the Bolts |
|
|
touch the Upright; do not fully tighten the |
| 80 |
Bolts yet. |
| |
| 8 |
|
