54
APPENDIX

NOTE ON THE LAMP REPLACEMENT INDICATOR AND MESSAGE

The LAMP REPLACEMENT INDICATOR and the warning message "LAMP REPLACEMENT" indicates the
guide of the lamp life.
It is unnecessary to replace the lamp immediately if the projector is operating normally with the indicator on.
If the LAMP REPLACE INDICATOR is lit (and warning message "LAMP REPLACEMENT" is displayed on the
screen) and the power is not be turned on by pressing the power button (Power is turned off approximately 20
seconds after power button is pressed.), the lamp replacement is required. Please contact a service for the lamp
replacement.
Follow these steps to replace the lamp assembly.
1. Turn off the projector and allow the projector to cool thoroughly.
2. Disconnect the AC cord from the projector.
3. Remove 2 screws with a screwdriver and disconnect the lamp cover.
4. Remove 2 screws with a screwdriver and pull out the lamp assembly by
grasping the handle.
5. Replace the lamp assembly.
6. Tighten 4 screws to secure the lamp cover to the lamp assembly.
7. Connect the detachable AC cord to the projector.
8. Reset the lamp replacement monitor timer.
(See "LAMP AGE" section on page 52.)
NOTE: Do not reset the LAMP REPLACEMENT MONITOR TIMER, except
after the lamp is replaced.
●For continued safety, replace with a lamp assembly of the same type.
●Allow the projector to cool for at least 45 minutes before you open the lamp cover. The inside of the
projector can become very hot.
●Do not drop the lamp module or touch the glass bulb ! The glass can shatter and cause injury.
LAMP
REPLACEMENT
INDICATOR
LAMP
ASSEMBLY
HANDLE
LAMP
COVER
LAMP REPLACEMENT
When the Projection Lamp of this projector draws to an end, the LAMP
REPLACEMENT indicator lights yellow and the warning message "LAMP
REPLACEMENT" appears as the right figure. When the warning message is
displayed, the Projection Lamp should be replaced.
To terminate the warning message.
Replace the Projection Lamp and reset the LAMP REPLACEMENT MONITOR
TIMER (See "LAMP AGE" section on page 52.), and the warning message is
terminated.
To erase the warning message in a moment.
To erase the warning message for a moment, move the arrow to "YES" by
pressing the POINT UP/DOWN BUTTON(s) and then press the SELECT (REAR
CLICK) BUTTON. This procedure is temporary measure, and the warning
massage appears again when the projector is turned on next time.
LAMP REPLACEMENT