PSC 8500 56,QWHUFKDUDFWHU'HOD\

6-80 0DJHOODQ 6FDQQHU
56,QWHUFKDUDFWHU'HOD\
Specifies delay between the end of one character and the beginning of the
next in 10-millisecond increments.
To set the RS-232 Intercharacter Delay:
1. Scan the SWITCH bar code.
2. Scan the bar code below, SET RS-232 INTERCHARACTER
DELAY. You’ll need to cover any unused bar codes on this and
the facing page to ensure that the scanner reads only the bar code
you intend to scan.
3. Scan the appropriate digits from the keypad in Appendix C that
represent the desired delay. The selectable range is 0-100, which is
the delay in 10-millisecond increments. Pad all single and double
digit numbers with leading zeroes to yield a three-digit entry
(000-100).
Examples:
001 = 10ms
005 = 50ms
040 = 400ms
100 = 1,000ms (1 second)
4. The scanner will automatically exit Programming Mode when the
appropriate amount of digits have been scanned.
SET RS-232 INTERCHARACTER DELAY