Steps For Installing Headrest with Shroud
Setup work
Remove the headrest and set it in an uncluttered work area. Pay the appropriate precautions to ensure that it is not damaged during the installation.
CAUTION: make sure the screws are not long enough to go through the headrest!
If you have any doubts about this type of installation, please consult your local mobile electronics retailer. Cutting and making holes in the headrest will cause electronic damage which is expensive to repair.
Measurements
Press the headrest with your fingers to make sure there are no obstructions that would hinder the installation. Use paper template to mark the area to be cut.
Cut the headrest
Use an
Remove foam & obstructions
Carefully peel off the material. Set the adjustable blade to one inch depth and cut around the edges of the hole, staying 1/4 inch inside the edge. Pull up one corner of the foam and use the blade to cut underneath. Remove small section at a time and ensure to be the uniform depth. Use a dremel or other appropriate
tools to remove other obstructions. Insert the monitor to measure the fit and make adjustment if necessary
7
