10
WARNING:
The following command might cause a loss of connections to the MGMT port.
IPv4 Interface (0=Enable, 1=Disable) [Enabled ]
IPv4 Mode (0=Static, 1=DHCP, 2=Bootp, 3=Rarp) [Dhcp ] 0
IPv4 Address [10.0.0.1 ] 172.17.136.55
IPv4 Subnet Mask [255.0.0.0 ] 255.255.254.0
IPv4 Gateway [0.0.0.0 ] 172.17.136.1
IPv6 Interface (0=Enable, 1=Disable) [Disabled ]
All attribute values that have been changed will now be saved.
Connect to host lost.
3. Select the blade you want to configure by issuing one of the following CLI commands:
blade 1
blade 2
4. At the prompt, issue the following CLI commands (for blade 2):
iSR6200 (admin)#> admin start (the default password is config)
iSR6200 (admin)#> set mgmt
5. Specify the mode. QLogic recommends using a static address. Select option 0, and then enter the IP
address, subnet mask, and gateway, if applicable.
You will lose the connectivity of the Telnet session at this time.
6. If you want to continue using the CLI, restart the Telnet session with the IP address you just assigned
to the management port.
You now have the management port configured with the appropriate IP address.
7. Connect the management port cable to your Ethernet network. Connect cables to the iSCSI and Fibre
Channel ports (GE1, FC1, and FC2, as well as the blade option ports based on model), as shown in
the configuration diagrams (Figure1 and Figure 2).
8. If necessary, repeat these procedures to configure your second blade.
Step 9. Present LUNs to iSCSI Initiators
1. If the iSR6200 is connected in the Fibre Channel fabric, make sure the Fibre Channel fabric zoning is
set so that Fibre Channel storage array ports and router Fibre Channel ports are in the same zone.
2. Using storage array management software, create all LUNs that you want to present to all iSCSI
initiators through this iSR6200. Present the LUNs from the Fibre Channel storage array to the iSR6200
using the WWPNs of this iSR6200. If you are setting up a high availability (HA) configuration that
uses two iSR6200s as a pair, present the LUNs to both iSR6200s using Fibre Channel WWPNs of
both iSR6200s.