Manuals / Brands / Computer Equipment / Network Router / Q-Logic / Computer Equipment / Network Router

Q-Logic I S R 6 2 0 0 Step 10. Configure Second Blade (if provided)

1 24

Download 24 pages, 1.95 Mb

15

After the iSCSI initiator logs into the newly presented LUN, the iSCSI Initiator Properties Targets page

(see Figure12) shows the target status as Connected.

Figure 12. iSCSI Initiator Properties: Target Connected

Now, when you select your iSCSI initiator in the left pane of the SANsurfer Router Manager window,

the Information page shows the status as Logged In. The LUN List page (Figure13) shows the LUNs

mapped to that initiator.

Figure 13. LUN List Page

Step 10. Configure Second Blade (if provided)

To configure a second blade (if provided), repeat Step9. Use Table2 on page 5 to build the blade optio n configuration.

Contents

Main Purchasers of OEM products should consult with the OEM for support. Quick Start Guide Suggested Configurations Installation Instructions Step 1. Verify the Package Contents Step 2. Complete the Pre-Installation Checklist Step 3. Mount the Router Step 4. Insert Additional Blade into Router (as needed) Step 5. Install the SFP Transceivers Step 6. Apply Power to the Router Page Step 7. Download and Install SANsurfer Router Manager Step 8. Configure the iSR6200 Management Port IP Address Step 9. Present LUNs to iSCSI Initiators Page Page Page Page Step 10. Configure Second Blade (if provided) Step 11. Configure an FCIP Route Step 12. Locate the Blade Serial Number for License Key Activation Serial Number Formats Using the CLI to Locate the Serial Number Using the GUI to Locate the Serial Number