9
Step 7. Download and Install SANsurfer Router Manager
Follow these steps to download the SANsurfer Router Manager tool from the QLogic Web site and install it on a
workstation:
1. Close all programs currently running.
2. Go to the QLogic Downloads and Documentation page located here:
http://driverdownloads.qlogic.com/
3. Under QLogic Products, type iSR6200 in the search box.
(Alternatively, you can click the Guided Search link to obtain assistance in locating the utility to
download.)
4. In the Resource Name column, click the SANsurfer Router Manager version for your operating system.
5. Click Download Now.
6. Save the file to your computer.
7. Run the installer. (If your Internet browser displays a security warning, you can safely bypass it.)
8. Follow the prompts in the SANsurfer Router Manager installation wizard.
Step 8. Configure the iSR6200 Management Port IP Address
1. Using a switch or hub, connect the router’s management port (10/100 Ethernet) to your workstation.
As an alternative, you may directly connect your workstation to the router using an Ethernet crossover
cable.
The iSR6200 management port’s default IP address is 10.0.0.1, subnet 255.0.0.0. Make sure the
workstation connected to the iSR6200 router has Ethernet address 10.0.0.x, where x is other than 1
and subnet mask is 255.0.0.0.
2. From the workstation, open a command window and using a Telnet session, follow these steps:
a. Connect to the iSR6200 using IP address10.0.0.1.
b. Log in as guest, and use the password password.
The following shows the iSR6200 command line interface (CLI) window.
iSR6200 login: guest
Password:
******************************************************
* *
* ISR6200 *
* *
******************************************************
iSR6200 #> blade 1
iSR6200 <1> #> admin start -p config
iSR6200 <1> (admin) #> set mgmt
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.