QSD004 User’s Manual
5.14 Motion Set
MOTION SET |
| |
MOTION RECORD TIME: | 10 | |
MOTION ALARM TIME: | OFF | |
MOTION SET |
|
|
PRESS (UP, DOWN), | ENTER (SELECT) | |
PRESS (MENU) TO | EXIT |
|
|
|
|
MOTION SET:
MOTION RECORD TIME:
This number indicates how many seconds the motion detection recording continues after a motion triggered event ends.
MOTION ALARM TIME:
This number indicates how many seconds the buzzer inside the DVR will sound after the DVR has been triggered by motion.
CONT: Continuous alarm until press any key to stop.
OFF: No alarm
MOTION DETECTION SET
>CHANNEL 1 SENSITIVITY 4
CHANNEL 2 SENSITIVITY 4
CHANNEL 3 SENSITIVITY 4
CHANNEL 4 SENSITIVITY 4
CHANNEL 1 AREA SET
CHANNEL 2 AREA SET
CHANNEL 3 AREA SET
CHANNEL 4 AREA SET
PRESS (UP, DOWN), | ENTER (SELECT) |
PRESS (MENU) TO | EXIT |
AREA SET:
SENSITIVITY:
Use [
Up] and [ Down] button to
select the channel you want to modify,
press [
SEL] to adjust sensitivity of
motion detection on each channel.
High | 9, OFF) Low |
When it’s “OFF”, the channel cannot be triggered by motion.
Use [
Up] and [ Down] buttons to select the channel you want to modify, press [
SEL] button to enter the sensitive area of each camera. The picture of the selected channel is divided into 144(12*12) blocks, press [REW] to move left, press [FWD] to move right, press[
Up] and [ Down] to move the cursor up and down, press [
SEL] to set the block active or not.
When the block is transparent, it’s active to record. When the block is covered by shadow, it is not active, and motion in this area will NOT be detected.
Make sure Record Schedule is set to Motion for the times required.
- 11 -
