Q-See QSD6204 manual General Safety

Models: QSD6204

1 48
Download 48 pages 53.24 Kb
Page 3
Image 3

GENERAL SAFETY

Review the following safety precautions to avoid injury and prevent damage to this product or any products connected to it.

1. Use proper power source

Do not operate this product from a power source that applies more than the specified voltage (90~260 VDC).

2. Do not insert anything metallic into the DVR case.

Putting something into the DVR case can be a source of dangerous electronic shock.

3.Do not operate in wet or dusty conditions.

Avoid places like a damp basement or dusty hallway.

4.Do not expose this product to rain or use near water.

If this product accidentally gets wet, unplug it and contact an authorized dealer

immediately.

5.Keep product surfaces clean and dry.

To clean the outside case of the DVR, use lightly dampened cloth with water (no

solvents).

6.Provide proper ventilation.

This DVR has a built in fan that properly ventilates the system.

7.Do not operate with suspected failures.

If there are any unusual sounds or smells coming from the DVR, unplug it

immediately and contact an authorized dealer or service center.

8.Do not attempt to remove the DVR cover.

Warning: You may be subjected to severe electrical shock if you remove the cover

of the DVR.

9.Handle DVR box carefully.

If the DVR is dropped on any hard surface it may cause a malfunction, If it stops

working properly due to physical damage contact an authorized dealer for repair or exchange.

10.Use standard lithium cell battery. (NOTE: Manufacturer has preinstalled battery.)

The standard lithium cell 3v battery located on the mother board should be replaced if the time clock does not hold its time after the power is turned off. Warning: unplug the DVR before replacing battery or you may be subjected to severe electrical shock. Properly dispose of old batteries.

11.Install this product where there is good air circulation.

This DVR system contains a hard drive which generates much heat during operation. Therefore do not block the air holes (bottom, upper side and back) of the DVR that cool down the system while running. Install or place this product in an area where there is good air circulation.

Page 3
Image 3
Q-See QSD6204 manual General Safety