In this example, Channel 1 has sensors installed, Open and Close, respectively.
MOTION DETECTOR SETUP
This indicates the sub menu for setting up the software motion detection without any external sensor devices.
| In this example, Channel 1 has Motion Detection enabled. |
MOTION | The image below shows the Motion Detection Area setup. As you |
SENSOR | see in the example below there are 3 shaded regions. Each region |
RECORDING | represents different levels of motion sensitivity required to activate |
| sensor recording. |
Adjust the sensitivity by first selecting the specific region in the view you would like to set. Then press ‘STOP’ button to adjust the sensitivity.
A blinking block (cursor) shows the particular setting sensitivity for that block. The Level 0 setting means the block area is disabled. Level 3 is the highest level of sensitivity. By pushing the “SELECT” button you can choose the sensitivity of the blinking block.
